| Redisplay Messages: Compact | Brief | All | Full Show Messages: All | Without Replies Author: | calsbricks | Posted: | May 27, 2019 05:50 | Subject: | Helpful but .... | Viewed: | 233 times | Topic: | Suggestions | Status: | Open | Vote: | [Yes|No] | |
| Firstly let me say that we know suggestions are not being implemented and according
to MP no work is being done on the classic site however this is a small request
which doesn't require huge amounts of development time and would make life
a bit easier.
Currently the method of manually adding inventory is long winded, provides no
audit trail of what has been done and at best is clumsy.
We use Brickstock for most of our updates to our store. It is much easier, quicker
and provides us with a complete audit trail - the only real snag is what happens
when the file gets to Bricklink, The verify screen drops off the Bricklink part
number for some reason so we are left with an audit trail which, when variants
are involved, isn't really all that helpful, although to be fair we have
used this for some time.
Simply placing the bricklink product code on the verify screen would be very
helpful and this is not a major programming issue. At the same time give us a
print button to print that screen Using the print command from the browser doesn't
work well with the page setup falling short of what is needed.
This is a simple matter and could be resolved in minimal time - please implement.
|
|
Author: | calsbricks | Posted: | Nov 23, 2018 00:38 | Subject: | Inventory Change Request for Set 40145-1 | Viewed: | 154 times | Topic: | Inventories Requests (Entry) | Status: | Open | |
| Please make changes to the following inventory:
* Add 2 Part 4085b Orange Plate, Modified 1 x 1 with Clip Vertical - Type 2 (thin U clip) (Alternate)
Comments from Submitter:
6 sets parted out 2 had the b variant not d.
|
Author: | calsbricks | Posted: | Nov 21, 2018 12:03 | Subject: | Inventory Change Request for Set 40222-1 | Viewed: | 225 times | Topic: | Inventories Requests (Entry) | Status: | Open | |
| Please make changes to the following inventory:
* Add 2 Part 4085b Orange Plate, Modified 1 x 1 with Clip Vertical - Type 2 (thin U clip) (Alternate)
Comments from Submitter:
5 Sets parted out - all b's not d's
|
Author: | calsbricks | Posted: | Nov 21, 2018 09:39 | Subject: | Inventory Change Request for Set 40222-1 | Viewed: | 197 times | Topic: | Inventories Requests (Entry) | Status: | Open | |
| Please make changes to the following inventory:
* Add 1 Part 44567b Light Bluish Gray Hinge Plate 1 x 2 Locking with 1 Finger on Side without Bottom Groove (Alternate)
* Add 1 Part 44302b Dark Bluish Gray Hinge Plate 1 x 2 Locking with 2 Fingers on End without Bottom Groove (Alternate)
Comments from Submitter:
5 sets parted out all without groove.
|
Author: | calsbricks | Posted: | Nov 8, 2018 11:39 | Subject: | Try that again | Viewed: | 224 times | Topic: | Catalog | Status: | Open | |
| - Not swure thie is correct in the catalogue. In all 3 sets that
it comes in there is an white rubber band which holds the two halves
together. The instructions show the rubber band being used in each case. Should
there be an inventory for the part?
|
Next Page: 5 More | 10 More | 25 More | 50 More | 100 More
|
|