Discussion Forum: Thread 353236

 Author: NotABot... View Messages Posted By NotABot...
 Posted: Jan 28, 2024 15:30
 Subject: Stacking Modified Tiles
 Viewed: 106 times
 Topic: Related Software
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

NotABot... (0)

Location:  USA, South Carolina
Member Since Contact Type Status
Jan 28, 2024 Contact Member Buyer
Buying Privileges - OK
Whenever I try to use 2x2 tiles with studs on top, it defaults to placing one
tile below the other instead of putting them side by side. Can anybody help me
out here?
 Author: iprice View Messages Posted By iprice
 Posted: Jan 28, 2024 15:51
 Subject: Re: Stacking Modified Tiles
 Viewed: 43 times
 Topic: Related Software
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

iprice (1249)

Location:  United Kingdom, England
Member Since Contact Type Status
Apr 15, 2018 Contact Member Buyer
Buying Privileges - OK
In Help, NotABot... writes:
  Whenever I try to use 2x2 tiles with studs on top, it defaults to placing one
tile below the other instead of putting them side by side. Can anybody help me
out here?

I presume you're talking about the part ins Studio? If so the proper Studio
forum is here - https://forum.bricklink.com/

However to help with this issue, you could always place a plate underneath where
you want the parts and then attach to that, then delete the plate.

I'm not noticing any issues with placing these parts side by side though.
There is a grid setting which adjusts fine movements. You could also try turning
on/off part-snapping.