Discussion Forum: Thread 353199

 Author: brazilbean View Messages Posted By brazilbean
 Posted: Jan 27, 2024 17:11
 Subject: Bricklink Studio on Mac 14.2
 Viewed: 48 times
 Topic: Related Software
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

brazilbean (0)

Location:  USA, Utah
Member Since Contact Type Status
Jan 27, 2024 Contact Member Buyer
Buying Privileges - OK
Studio 2.0 opens with a dialog box about upgrading to 2.23 and immediately becomes
unresponsive. I have to force-quit the program.

Studio 2.23 is extremely buggy. It is sporadic in how it responds to the mouse-sometimes
it allows me to move a piece, sometimes it is unresponsive. Sometimes the pieces
refuse to snap to the grid and end up sitting between two positions. If I enter
camera pivot mode (right click), it will NOT exit camera-pivot and I have to
force-quit the program.

Please let me know when either of these options are functioning again on Mac.
I would love to create some builds with my son. Thank you.
 Author: SylvainLS View Messages Posted By SylvainLS
 Posted: Jan 28, 2024 07:53
 Subject: Re: Bricklink Studio on Mac 14.2
 Viewed: 30 times
 Topic: Related Software
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

SylvainLS (46)

Location:  France, Nouvelle-Aquitaine
Member Since Contact Type Status
Apr 25, 2014 Contact Member Seller
Buying Privileges - OKSelling Privileges - OK
Store Closed Store: BuyerOnly
BrickLink Discussions Moderator (?)
In Related Software, brazilbean writes:
  Studio 2.0 opens with a dialog box about upgrading to 2.23 and immediately becomes
unresponsive. I have to force-quit the program.

Studio 2.23 is extremely buggy. It is sporadic in how it responds to the mouse-sometimes
it allows me to move a piece, sometimes it is unresponsive. Sometimes the pieces
refuse to snap to the grid and end up sitting between two positions. If I enter
camera pivot mode (right click), it will NOT exit camera-pivot and I have to
force-quit the program.

Please let me know when either of these options are functioning again on Mac.
I would love to create some builds with my son. Thank you.

Hi,

It’s a known problem between Sonoma and Unity (with which Studio is built): https://forum.bricklink.com/viewtopic.php?t=9874

A lot of users have been caught in it: https://forum.bricklink.com/viewtopic.php?t=9775

A fix is coming, but, in the meantime you can:
— Use the EarlyAccess version in fullscreen mode.
— Use the Windows version with Wine/Whisky.


Also, as you can notice, all the posts are on the dedicated forum for Studio
and PartDesigner, https://forum.bricklink.com/ (hover over the red Studio icon
on every page, then click “Studio Forum”), which is where one should look for
info first