| Discussion Forum: Thread 352662 |
|
 |
| | | Author: | ImagineMOCs  | | Posted: | Jan 14, 2024 05:25 | | Subject: | Stud.io incorrect part design (11477) | | Viewed: | 42 times | | Topic: | Related Software | |
|
| Hello,
I am trying to make to make a moc in Studio and I want to used a curved slope
without any print designs on it. The piece in question I want to use is part
11477 (the same piece used in the 2023 Star Wars 501st battle pack). However,
the design it shows for this in Studio isn't curved, but instead is somewhat
"cornered." I have included an image below to show what I mean
On the right it shows part 11477 with a print on it. This is the correct shape
for the piece I am looking for, however I do not want the print on it. On the
left is also part 11477 but without the print. For some reason though the shape
is incorrect. It is not curved like the piece on the right. Why is this?
I have never had this issue before. Out of curiosity I tried to open some of
my older projects that also used part 11477 without the print and lo and behold,
the piece design was no longer curved but somewhat "cornered."
I tried uninstalling and reinstalling Stud.io but that didn't manage to work.
I also tried saving the piece from the bricklink website so I could see if it
would turn up in my saved parts in Studio but that did not fix the problem.
Is anyone else running into this issue? Are there any fixes?
|
|
|
|
| | | | | |
| | | | | Author: | SylvainLS | | Posted: | Jan 14, 2024 05:59 | | Subject: | Re: Stud.io incorrect part design (11477) | | Viewed: | 25 times | | Topic: | Related Software | |
|
| In Related Software, ImagineMOCs writes:
Hi,
| | I am trying to make to make a moc in Studio
|
FYI, the dedicated forum for Studio and PartDesigner is https://forum.bricklink.com/
(hover over the red Studio icon on every page, then click “Studio Forum”).
Please search the forum for your question before posting a new one (the search
box is in the very dark grey banner).
There’s indexes of known bugs and suggestions that you can browse first:
Studio: https://forum.bricklink.com/viewtopic.php?f=4&t=5579
PartDesigner: https://forum.bricklink.com/viewtopic.php?f=10&t=5589
| | and I want to used a curved slope
without any print designs on it. The piece in question I want to use is part
11477 (the same piece used in the 2023 Star Wars 501st battle pack). However,
the design it shows for this in Studio isn't curved, but instead is somewhat
"cornered." I have included an image below to show what I mean […]
|
It’s because your render settings are not set high enough.
Go in Edit | Preferences | Appearance and push the slider to the right. That
should solve it 
(That slider affects Build mode (aspect and collisions), Instruction mode, and
renders.)
|
|
|
|
|
|
|
USA, Idaho
France, Nouvelle-Aquitaine