Discussion Forum: Thread 341373 |
|
|
| | Author: | eracine | Posted: | Jun 15, 2023 14:38 | Subject: | help desk question | Viewed: | 70 times | Topic: | Help | |
|
| Was filling out a help desk form and gave all the information required and hit
the submit button but after doing so it said page can't be displayed due
internal server error. Am I to assume the form wasn't sent? Thanks just
trying to resolve a NSS issue.
Eric
|
|
| | | | | |
| | | | Author: | SylvainLS | Posted: | Jun 15, 2023 14:44 | Subject: | Re: help desk question | Viewed: | 20 times | Topic: | Help | |
|
| In Help, eracine writes:
| Was filling out a help desk form and gave all the information required and hit
the submit button but after doing so it said page can't be displayed due
internal server error. Am I to assume the form wasn't sent? Thanks just
trying to resolve a NSS issue.
Eric
|
Maybe, maybe not. Who knows?
Was it on the helpdesk site or were you answering in the NSS?
|
|
| | | | | |
| | | | Author: | Nubs_Select | Posted: | Jun 15, 2023 14:44 | Subject: | Re: help desk question | Viewed: | 21 times | Topic: | Help | |
|
| that is usually the error bricklink gives when something is chosen wrong for
example you use a minifigure number while requesting a change in the part form
instead of the figure forum and similar so maybe double check that you selected
everything correctly
|
|
| | | | | | | | | |
| | | | | | Author: | SylvainLS | Posted: | Jun 15, 2023 14:48 | Subject: | Re: help desk question | Viewed: | 22 times | Topic: | Help | |
|
| In Help, Nubs_Select writes:
| that is usually the error bricklink gives when something is chosen wrong for
example you use a minifigure number while requesting a change in the part form
instead of the figure forum and similar so maybe double check that you selected
everything correctly
|
Good practice would be to say “You’re holding it wrong.”
|
|
| | | | | | | | | | | | | |
| | | | | | | | Author: | eracine | Posted: | Jun 15, 2023 15:51 | Subject: | Re: help desk question | Viewed: | 22 times | Topic: | Help | |
|
| In Help, SylvainLS writes:
| In Help, Nubs_Select writes:
| that is usually the error bricklink gives when something is chosen wrong for
example you use a minifigure number while requesting a change in the part form
instead of the figure forum and similar so maybe double check that you selected
everything correctly
|
Good practice would be to say “You’re holding it wrong.”
|
|
|
|
|
|
|