| Discussion Forum: Thread 283358 |
|
 |
| | | Author: | axaday  | | Posted: | Feb 5, 2021 23:10 | | Subject: | Inventory Change Request for Set 7047-1 | | Viewed: | 21 times | | Topic: | Inventories Requests (Entry) | | Status: | Open | |
|
| Please make changes to the following inventory:
* Change 3 Part Yellow {4623 Plate, Modified 1 x 2 with Bar Arm Up (Undetermined Horizontal Arm Length) to 4623a Plate, Modified 1 x 2 with Bar Arm Up (Horizontal Arm 6mm)}
Comments from Submitter:
Sealed set, pic following
|
|
| | | | | |
| | | | | Author: | axaday | | Posted: | Feb 5, 2021 23:12 | | Subject: | Re: Inventory Change Request for Set 7047-1 | | Viewed: | 14 times | | Topic: | Inventories Requests | |
|
| In Inventories Requests, axaday writes:
| | Please make changes to the following inventory:
* Change 3 Part Yellow {4623 Plate, Modified 1 x 2 with Bar Arm Up (Undetermined Horizontal Arm Length) to 4623a Plate, Modified 1 x 2 with Bar Arm Up (Horizontal Arm 6mm)}
Comments from Submitter:
Sealed set, pic following
|
This pic didn't turn out as well as I thought when I took it. In the fuzzy
pic, it looks at a glance like the piece slid over while measuring, but it didn't.
The edge you can see along the caliper blade is the 3D front edge of the piece.
|
|
|
|
|
|
|
USA, Oklahoma
