Discussion Forum: Thread 252850 |
|
|
| | Author: | moin99 | Posted: | May 28, 2019 18:50 | Subject: | Inventory Change Request for Set 7745-1 | Viewed: | 32 times | Topic: | Inventories Requests (Entry) | Status: | Open | |
|
| Please make changes to the following inventory:
* Delete 3 Part 766c28 Light Gray Electric, Wire 12V / 4.5V with 2 Leads, 28 Studs (22cm) Long with 2 Light Gray Electric, Connector, 2-Way Male Squared Narrow Long with Center Post
Comments from Submitter:
it is not possible to build the 7745 with this wire, because the 4093b train base has 28 studs, too.the correct wire for 7745 is 34 studs long, but this is not listed at bl.
|
|
| | | | | |
| | | | Author: | SezaR | Posted: | May 28, 2019 19:42 | Subject: | Re: Inventory Change Request for Set 7745-1 | Viewed: | 22 times | Topic: | Inventories Requests | |
|
| In Inventories Requests, moin99 writes:
| Please make changes to the following inventory:
* Delete 3 Part 766c28 Light Gray Electric, Wire 12V / 4.5V with 2 Leads, 28 Studs (22cm) Long with 2 Light Gray Electric, Connector, 2-Way Male Squared Narrow Long with Center Post
Comments from Submitter:
it is not possible to build the 7745 with this wire, because the 4093b train base has 28 studs, too.the correct wire for 7745 is 34 studs long, but this is not listed at bl.
|
I believe this request should be rejected. We cannot just remove one part unless
if we can add the replacement. By just removing this part, there would not be
any wire for this set.
We know there are whole problems with wires, concerning their lengths, names,
the way they should be measured,... . See
https://www.bricklink.com/message.asp?ID=1136906
I have this set in new condition NIB (and few other used sets). I will later
check the length of wires.
|
|
|
| | | | | | | | | |
| | | | | | Author: | SezaR | Posted: | May 29, 2019 06:35 | Subject: | Re: Inventory Change Request for Set 7745-1 | Viewed: | 18 times | Topic: | Inventories Requests | |
|
| In Inventories Requests, SezaR writes:
| In Inventories Requests, moin99 writes:
| Please make changes to the following inventory:
* Delete 3 Part 766c28 Light Gray Electric, Wire 12V / 4.5V with 2 Leads, 28 Studs (22cm) Long with 2 Light Gray Electric, Connector, 2-Way Male Squared Narrow Long with Center Post
Comments from Submitter:
it is not possible to build the 7745 with this wire, because the 4093b train base has 28 studs, too.the correct wire for 7745 is 34 studs long, but this is not listed at bl.
|
I believe this request should be rejected. We cannot just remove one part unless
if we can add the replacement. By just removing this part, there would not be
any wire for this set.
We know there are whole problems with wires, concerning their lengths, names,
the way they should be measured,... . See
https://www.bricklink.com/message.asp?ID=1136906
I have this set in new condition NIB (and few other used sets). I will later
check the length of wires.
|
I checked one copy of my 7745. The length of wires for three wire/connector assemblies
(without connectors) were 24cm and the forth one 23.6cm.
|
|
|
| | | | | |
| | | | Author: | randyf | Posted: | May 30, 2019 02:16 | Subject: | Re: Inventory Change Request for Set 7745-1 | Viewed: | 21 times | Topic: | Inventories Requests | |
|
| In Inventories Requests, moin99 writes:
| Please make changes to the following inventory:
* Delete 3 Part 766c28 Light Gray Electric, Wire 12V / 4.5V with 2 Leads, 28 Studs (22cm) Long with 2 Light Gray Electric, Connector, 2-Way Male Squared Narrow Long with Center Post
Comments from Submitter:
it is not possible to build the 7745 with this wire, because the 4093b train base has 28 studs, too.the correct wire for 7745 is 34 studs long, but this is not listed at bl.
|
At this time, we will not be changing any wire lengths in the inventories until
we have a standard way to measure them and apply this standard to all wires in
the catalog and inventories. I hope to get this project underway sometime this
summer (for those in the Northern Hemisphere).
Cheers,
Randy
|
|
|
|
|
|
|