Discussion Forum: Thread 244550 |
|
|
| | Author: | irregular | Posted: | Nov 18, 2018 11:29 | Subject: | About 3039pb088 Stickers in 10195 AT-OT | Viewed: | 54 times | Topic: | Catalog | Status: | Open | |
|
| Hello,
I was checking parts on a "Republic Dropship with AT-OT Item No: 10195-1" here:
https://www.bricklink.com/v2/catalog/catalogitem.page?S=10195-1#T=I
I noticed that in my set I followed the first set of instructions. I've attached
the relevant part from page 30 just in case.
When I check the bricklink parts list I noticed that it shows up as two same
parts with the sticker going up, not two different parts, one up and the other
down.
I realize this is a detail, I'm curious to know if this is relevant to bricklink
and how this is managed and/or changed.
Thank you.
|
|
|
| | | | | |
| | | | Author: | StormChaser | Posted: | Nov 18, 2018 12:21 | Subject: | Re: About 3039pb088 Stickers in 10195 AT-OT | Viewed: | 32 times | Topic: | Catalog | |
|
| In Catalog, irregular writes:
| I realize this is a detail, I'm curious to know if this is relevant to bricklink
and how this is managed and/or changed.
|
It is a detail, yes. Perhaps someone with better knowledge of Star Wars sets
than I have can comment upon it. If it needs to be corrected, then it would
merely necessitate adding a new catalog entry for the part with the sticker upside
down.
|
|
|
| | | | | | | | | |
| | | | | | Author: | irregular | Posted: | Nov 18, 2018 15:10 | Subject: | Re: About 3039pb088 Stickers in 10195 AT-OT | Viewed: | 27 times | Topic: | Catalog | |
|
| Hello,
Thank you for answering.
I would think it would need correcting since it is there in the instructions
but I'm very new here and I wouldn't know how to. Let's see if someone
with better knowledge makes the changes.
In Catalog, StormChaser writes:
| In Catalog, irregular writes:
| I realize this is a detail, I'm curious to know if this is relevant to bricklink
and how this is managed and/or changed.
|
It is a detail, yes. Perhaps someone with better knowledge of Star Wars sets
than I have can comment upon it. If it needs to be corrected, then it would
merely necessitate adding a new catalog entry for the part with the sticker upside
down.
|
|
|
|
|
|
|